Download Print this page

Javad JLink LTE How To Set Up

As hotspot

Hide thumbs Also See for JLink LTE:

Download this manual

The purpose of this document is to describe how to configure JLink LTE as hotspot.

The following are the steps of configuration of JLink LTE:

 Connect to Jlink LTE via web interface (For more detail see document "JLink LTE User Menual").

 Insert SIM card (For more detail see document "JLink LTE User Menual").

 GSM configuration:

◦ In the Communication/GSM. tab. (see Picture 1):

setup GSM network configuration parameters if it is needed.

◦ In the Communication/Power Management tab activate the GSM module

(see Picture 2)

How to setup JLink LTE as hotspot.

Picture 1. JLink LTE GSM parameters configuration tab

Page 1 The following are the steps of configuration of JLink LTE:  Connect to Jlink LTE via web interface (For more detail see document “JLink LTE User Menual”).  Insert SIM card (For more detail see document “JLink LTE User Menual”).
Page 2 Picture 2. JLink LTE Power Management tab ◦ Detailed connection status you can check in Status/GSM. tab (see Picture 3) Picture 3. JLink LTE GSM. Status tab...
Page 3 In the Administration/Management tab click “Reboot” button and wait until reboot ◦ (see Picture 5). Picture 5. JLink LTE Administration Management tab  Setup WIFI AP ◦ In the Communication/Wi-Fi tab select parameter “Adapter mode” to “AP”. Click “Save Setting” button and wait until finish (see Picture 6).
Page 4 Picture 6. JLink LTE WIFI configuration tab.