Javad JLink LTE How To Set Up

Provide rtk data received via ntrip client to uhf

Hide thumbs Also See for JLink LTE:

Download this manual

How to setup JLink LTE to provide RTK data received via NTRIP

The purpose of this document is to describe how to configure JLink LTE to provide RTK data received

via NTRIP Client to UHF.

The following are the steps of configuration of JLink LTE:

 Connect to JLink LTE via web interface (For more detail see document "JLink LTE User

Manual").

 Cellular (GSM ) configuration

◦ In the Communication/GSM tab. Set the PIN code and APN parameters (if necessary) (see

Picture 1).

◦ Please use tweezers to install or remove micro SIM card see (see Picture 2.a).

◦ Insert the SIM card to its slot. The first slot from the green top cover is for micro SIM, the

second slot is for micro SD (see Picture 2.b).

◦ In the Communication/Power Management tab activate the GSM interface (see Picture 3).

And wait for registering in the network and Internet access availability . Detailed connection

status you can check in Status/GSM tab (see Picture 4).

It is possible also to connect JLink LTE to Internet via LAN or Wi-Fi using any Wi-Fi router, MiFi

device or even smart-phone configured in hot spot mode.

Client to UHF.

Picture 1. JLink LTE GSM configuration tab

Page 1 And wait for registering in the network and Internet access availability . Detailed connection status you can check in Status/GSM tab (see Picture 4). It is possible also to connect JLink LTE to Internet via LAN or Wi-Fi using any Wi-Fi router, MiFi device or even smart-phone configured in hot spot mode.
Page 2 Picture 2. JLink LTE micro SIM card installation procedure Picture 3. Jlink LTE Power Management tab...
Page 3 Picture 4. JLink LTE GSM Status tab  Setup UHF ◦ In the Communication/UHF Int. tab select Modem parameters (see Picture 5). ◦ In the Communication/Power Management tab activate the UHF interface (see Picture 3).
Page 4 Picture 5. Jlink LTE UHF Int. tab  Setup Data Router In the Setup/Router tab select following parameters “NTRIP Client” as Source and ◦ “UHF“ as Destination. Click “Save Setting” button and wait until finish (see Picture 7).
Page 5 Picture 7. JLink LTE NTRIP Data Router tab  Setup NTRIP Client ◦ In the Services/NTRIP tab set following parameters: “Server name/address”, “Port”, “User” , “Password” . Click “Save Setting” button and wait until finish. Click '”Update” button and select “Mountpoint” .
Page 6 Picture 8. JLink LTE NTRIP configuration tab...
Page 7 Picture 9. JLink LTE Status NTRIP tab...