Javad HPT435BT JL How To Set Up

To provide rtk data received via ntrip client to uhf

Hide thumbs Also See for HPT435BT JL:

Download this manual

900 Rock Avenue, San Jose, CA 95131, USA

How to

Setup HPT435BT JL to provide RTK

data received via NTRIP Client to

UHF

Version 1.0

Last revised March 31, 2020

All contents in this manual are copyrighted by JAVAD GNSS.

displayed, sold, modified, published, or distributed, or otherwise reproduced without express

written consent from JAVAD GNSS.

Need help?

Do you have a question about the HPT435BT JL and is the answer not in the manual?

Page 1 Version 1.0 Last revised March 31, 2020 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved. The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
Page 2 HPT435BT JL to provide the RTK data received via NTRIP Client to UHF. The following are the steps of configuration of HPT435BT JL: 1. Connect to HPT435BT JL via web interface (see “HPT435BT JL User Manual” for the details). 2. Perform the Cellular (GSM ) configuration: •...
Page 3 The detailed connection status you can check in the Status/GSM tab (see Figure 4). It is possible also to connect HPT435BT JL to the Internet via LAN or Wi-Fi using any Wi-Fi router, MiFi device or even smart-phone configured in hot spot mode.
Page 4 HOW TO Figure 7. HPT435BT JL NTRIP configuration tab Figure 6. HPT435BT JL NTRIP Data Router tab • If the Ntrip caster needs NMEA-GGA which Setup NTRIP Client you can see in picture 8 (field Client must send NMEA-GGA is “Yes”), needed activate •...
Page 5 HOW TO Figure 8. HPT435BT JL Status NTRIP tab...