Primary-Secondary Set Up - Elation PROTEUS RAYZOR 1960 User Manual

P R I M A R Y- S E C O N D A R Y S E T U P
This function allows you to link units together to run in a Primary-Secondary set-up, in which
one unit will act as the controlling unit and the others will react to the controlling unit's
built-in programs. Any unit can be configured to act as a Primary or as a Secondary, but only
one unit in a given system can be programmed to act as the Primary.
PRIMARY-SECONDARY CONNECTIONS AND SETTINGS:
1. Daisy chain your units via the XLR connectors on the rear panels of each unit. Use stan-
dard XLR data cables to link your units together. Remember that the male XLR connector
is the input and the female XLR connector is the ouput. The first unit in the chain (pri-
mary) will use the female XLR connector only, while the last unit in the chain will use the
male XLR connector only.
2. On the primary unit, use the display screen and control panel to navigate to Function >
Auto Program, then use scroll to "Primary" and press ENTER.
3. On the secondary unit(s), use the display screen and control panel to navigate to Function
> Secondary Mode, and select one of the three available secondary groupings. Please refer
to the Record Controller section of this manual for more information regarding secondary
mode groupings.
4. Repeat Step 3 for each secondary unit in the system. Make sure that only one unit is des-
ignated as the Primary, while all other units are designated as Secondaries.
5. The secondary units will now follow the behavior of the primary unit.
60