Table of Contents
Advertisement
I N S TA L L AT I O N G U I D E L I N E S
ART-NET AND sACN CONNECTION
When connecting the fixture to a network switch to control multiple devices, a Gigabit
Ethernet Switch that supports IGMP (Internet Group Management Protocol) is required.
Using a Gigabit Ethernet Switch that does not support IGMP can cause erratic behavior of all
connected devices to the switch. Visit the link below for more information about IGMP.
https://en.wikipedia.org/wiki/Internet_Group_Management_Protocol
POWER AND DATA CABLES
TO MAINTAIN THE IP65 RATING INTEGRITY OF THE FIXTURE, ALL CABLES MUST
BE RUN TOWARDS THE GROUND IN ORDER TO PREVENT WATER ACCUMULATION
AROUND THE CONNECTIONS.
RJ45 DATA CABLES
T H E I N C LU D E D R J 4 5 DATA CA B L E I S F O R F I XT U R E TO F I XT U R E
INTERCONNECTIONS ONLY! THE RJ45 CABLE CONNECTORS MAY NOT BE
COMPATIBLE WITH OTHER RJ45 OR ETHERNET TYPE CONNECTORS.
POWER AND DATA CONNECTIONS
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) IN ORDER TO
PREVENT WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
TO MAINTAIN IP65 RATING INTEGRITY AND PREVENT WATER FROM ENTERING
THE FIXTURE, SEAL ALL UNUSED CONNECTION RUBBER CAPS.
CABLE
DIRECTION
Display
Screen
CABLE
DIRECTION
16
Advertisement
Table of Contents
