E-Fly Wireless Dmx Set Up - Elation DARTZ 360 User Manual

E - F L Y W I R E L E S S D M X S E T U P
BEFORE SETTING THE WIRELESS CHANNEL ON ANY E-FLY
FIXTURE, MAKE SURE THE SOURCE E-FLY WIRELESS DMX
TRANSCEIVER DEVICE IS OFF.
TO CONTROL FIXTURE WITH E-FLY WIRELESS DMX SIGNAL
1. Make sure the source E-FLY wireless DMX Transceiver device is powered OFF.
2. Power ON fixture and enable E-FLY in the E-FLY sub menu of the FUNCTION main menu.
3. Set the E-FLY wireless channel (00-14) to the same wireless channel of the source
E-FLY DMX Transceiver in the Wireless sub menu of the FUNCTION main system menu.
Erratic fixture movement may occur if other E-FLY wireless DMX products are in use
in the same area and are using the same E-FLY wireless channel. The fixture may
immediately start to respond to the DMX wireless signal from another E-FLY wireless
DMX Transceiver immediately when E-FLY is enabled. Make sure to know what
E-FLY wireless channels are being used in the area where fixture is being installed.
4. Set fixture DMX address in the Set Dmx Address sub menu of the RECEIVE main
system menu.
5. If an E-FLY wireless DMX connection has been made with the fixture, the E-FLY signal
Indicator on the LCD control panel will illuminate green.
6. Repeat this process for all E-FLY compatible fixtures in your E-FLY wireless network,
making sure all fixtures are assigned the same wireless channel (00-14).
7. After all fixtures in your E-FLY wireless network have been set and powered ON, then
power ON the source E-FLY™ DMX Transceiver device.
www.elationlighting.com
18