Elation PROTEUS RAYZOR 1960 User Manual page 19

I N S TA L L AT I O N
HIBERNATION MODE
This mode disables motors and most electronics in order to reduce wear on the fixture's inter-
nal components. The user has the ability the define the period of time that the fixture can
remain inactive before it enters hibernation mode. This feature can be accessed by navigating
in the main menu to PERSONALITY > STATUS SETTINGS > HIBERNATION (see the System Menu
section of this manual for detailed information). The default setting for hibernation delay
time is 15 minutes, but it can be adjusted from 1 min to 99 min, or switched off completely.
Hibernation mode is activated under the following conditions:
• Loss of DMX signal: the fixture enters hibernation after the timeout expires. Default is
15 minutes.
• Remote DMX control: Press and hold "Hibernate Fixture" for 3s.
Hibernation mode is deactivated under the following conditions:
• DMX signal is connected.
• Remote DMX control: Hold "Hibernate Off" for 3s.
The fixture will perform a full calibration cycle, then assume the current DMX status.
Please note that the Hibernation does not change the PT position of the fixtures. This allows
the user to set the desired position and then issue the Hibernate command.
To ensure the fixture is protected from harmful sunrays, it is recommended to either leave the
"No DMX Status" in "Sun Protection" mode (so that the fixture is already in the correct posi-
tion after 3 minutes of DMX loss) or set the fixture to a safe Pan Tilt position manually prior
to putting the fixture in hibernation mode.
Burn and heat damage to the fixture's interior components due to external light sources
(sun or other fixtures shining into the lens) is never covered under the manufacturer's
warranty.
19