Table of Contents
Advertisement
FLASH – CENTRAL OFFICE (CO) LINE
Feature 3
Flash – Central Office Line is a programmed setting that will determine what
flash timing will be presented to the telephone company central office when
the user issues a Hook-Flash command while connected to a CO line. This
feature is a requirement when the system is installed behind a Centrex or
PBX system. For easy access it is recommended, in these two cases, the
Flash feature code is programmed onto a Programmable Feature key.
If Call Waiting is provided, by the telephone company, the Flash feature is
used to answer a second incoming call while connected to another outside
party.
Conditions
1. The Flash code may be stored in any speed dial bin.
2. The Flash code may be stored in the Last Number Redial buffer.
3. SLT extensions must generate a hook-flash on the single line port the
dial #3 to generate a hook-flash on a CO line.
FORCED INTERCOM TONE RING
*
When an extension is in Hands Free - Voice Announce mode, intercom calls
will not forward, so the system allows callers to dial * to activate Forced
Intercom Tone Ring which allows callers to ring the extension.
Conditions:
1. When an extension leaves a callback, the alert signal will ring.
GROUP CALL PICK-UP
#54
See Call Pick-up.
HOLD
A Single Line Telephone can place calls on hold by pressing a fixed Flash
key or by pressing the hook-switch.
SINGLE LINE TELEPHONE USER GUIDE - 112
Advertisement
Table of Contents
