Table of Contents
Advertisement
Conditions
1. The system checks the Filter U (No Ring table), if it is active, and if a
match is found, then the action is taken, otherwise the system will check
Ring table if a match is found it will take that action. If there is no
match, no action is taken.
OPTIONAL SENSOR FUNCTION
The system can be equipped with up to four security sensor connections,
which when programmed can show if a device is left open. This function
requires the option module and ancillary equipment such as door sensors,
etc. The Attendant can set and reset the following sensor programming:
1. SC. AL. DELAY - A sensor will activate every time the contact is
opened. This means that the sensor alarm may activate several times
which may not be desirable. Therefore, the alarm delay (measured in
minutes) allows a preset time to pass before the alarm sensor activates.
2. SC. AL. Cancel - Like an alarm system, the telephone system can alert
internal or external parties of an open sensor. The Security Alarm
Cancel is a timer which allows the situation to be investigated before
sending the alert notification. This timer is adjustable from 0
(immediate) to 120 seconds. If the password is not entered within the
timer's setting, the system will begin the alert procedure.
3. SC. AL. Period - This is the period of time that the internal extension is
alerted for an open sensor. Any external numbers will continue until the
notification is complete or the Call Out Timer is reached (The Call Out
Timer is set in system administration programming.
4. SC. PSWD (0000) - The Sensor Control Password is used to reset an
alarm sensor once it has been activated.
ATTENDANT POSITION USER GUIDE - 97
Advertisement
Table of Contents
