Safety Instructions - HBM KMR Mounting Instructions

KMR
1

Safety instructions

A2114-1.1_en/de
Use in accordance with the regulations
The KMR are intended for the measurement of forces in
test rigs / press‐fit facilities / test systems / presses. Any
other use is deemed to be not in accordance with the
regulations.
In the interests of safety the transducer should be used
only as specified in the mounting instructions. It is also
essential to comply with the statutory and safety
regulations in force for the particular application. The
same applies to the use of accessories.
The transducer is not a safety device as defined for use
in accordance with the regulations. Perfectly safe
operation of this transducer demands appropriate
transport, as well as technically correct storage,
installation and mounting combined with careful operation
and maintenance.
General dangers due to non-observance of the
safety instructions
KMR comply with the state of the art and are fail‐safe.
The transducers can give rise to residual dangers if they
are inappropriately installed and operated by untrained
personnel.
Any person responsible for the installation,
commissioning, maintenance or repair of a force
transducer must have read and understood the mounting
instructions and in particular the technical safety
instructions.
3