12
S Monitoring press forces with pressure plates
The following measurement set‐up also enables you to
determine press forces. The hardened washers may be
omitted, if the hardness of the pressure plates is at least
43 HRC.
Fig. 6.3
Monitoring a pressing force
S Monitoring rope forces with tension rods
The KMR has been designed for compressive forces.
Due to its internal bore hole it may also be used to
monitor tensile forces. Take into account the tensile
strength of the tension element in use.
Stamp
Retainer
Blank
Die‐plate
KMR
Ejector
A2114-1.1_en/de
KMR