Master-Mode Boot; Return To Operations - Intermec 6200 Troubleshooting Manual

SECTION 3 Flash
"

Master-Mode Boot

"
NOTE: A Master-Mode Boot card is required, contact the Norand Customer Response Cen-
ter for this card. The computer must be on charge before doing these steps. Do not
interrupt power while reprogramming the flash, otherwise the Master-Mode Boot
process has to restart. A failed master-mode boot (seven beeps) may require cold-
booting the computer, removing ALL power and starting the computer again.
If the screen is still blank, reflash the computer with these steps:
1.
2.
"
NOTE:
Connect the computer to a charge source before doing this next step.
3.
4.
5.

Return to Operations

Do the following to put the computer in operating mode:
1.
2.
3.
4.
3-6 6200 and 6210 Hand-Held Computers Troubleshooting Guide
Remove all batteries and put the computer on charge.
Install a Master-Mode Boot card in the B: slot.
Press and hold the [ON] key on the front of the computer, then press
the reset switch. The computer should "beep" seven times as it at-
tempts to boot from the B: slot.
Count any beeps:
If no beeps are heard, the batteries may be low. Check the
"
batteries.
If seven beeps are heard but the computer does nothing else,
"
release the [ON] key and press the reset switch again.
Wait for the computer to prompt for the [3] key, then press the [3]
key. When done, the computer resets and the NORAND Utilities
screen appears.
Remove the Master-Mode Boot card.
Reinstall any PC Card or application cards and press down the PC
Card holder.
Reload any data that was not stored in the RAM disk.
Close and lock the PC Card compartment door.