Clearing Out Ram Drive; Master Mode Booting Computer - Intermec 6200 Troubleshooting Manual

"
"

Clearing Out RAM Drive

Do the following to clear all data and application programs from the com-
puter's RAM drive (drive C:):
1.
2.
3.
4.
5.

Master Mode Booting Computer

"
NOTE:
If the Master Mode Boot card is in the wrong slot, not present, or not loaded with
the proper image, the computer beeps seven times.
Keep in mind, for Master-Mode Booting, the [YES] key is for the 6200
Computer; the [ON] key is for the 6210 Computer. Do the following to
Master Mode Boot the computer:
1.
2.
3.
4.
5.
Contact your Norand Systems Engineer (SE) or Value Added Resel-
ler (VAR).
Contact the Norand Customer Response Center.
Press the reset switch and repeatedly press [F4]. The [F4] key must
be active while the computer "beeps" through the memory test during
the power-on self-test. The "ROM DOS 5" menu appears on the
LCD screen.
Press [4] for drive D: to bring up the NORAND Utilities menu.
Press [9] for the "Advanced Utilities" menu.
Press [3] to reformat the RAM drive.
Walk through the screens to set the size to zero or desired size.
Install the Master-Mode Boot card and connect the computer to a
charge source (recommended).
Press and hold the [YES] or [ON] key.
Press the reset switch. Continue to hold the [YES] or [ON] key until
the display stops changing.
The screen prompts to connect the computer to a charge source, press
[YES], then press [3] to reflash now. The computer updates flash
memory, then resets when completed.
Remove the Master Mode Boot card.
6200 and 6210 Hand-Held Computers Troubleshooting Guide 4-9
SECTION 4 Troubleshooting
"