Master-Mode Boot; Return To Operations - Intermec 6200 Troubleshooting Manual

SECTION 3 Flash
"

Master-Mode Boot

"
NOTE: A Master-Mode Boot card is required, contact the Norand Customer Response Cen-
ter for this card. The computer must be on charge before doing these steps. Do not
interrupt power while reprogramming the flash, otherwise the Master-Mode Boot
process has to restart. A failed master-mode boot (seven beeps) may require cold-
booting the computer, removing ALL power and starting the computer again.
If the screen is still blank, reflash the computer with these steps:
1.
2.
"
NOTE:
Connect the computer to a charge source before doing this next step.
3.
4.

Return to Operations

Do the following to put the computer in operating mode:
1.
2.
3.
3-4 6200 and 6210 Hand-Held Computers Troubleshooting Guide
Remove all batteries and put the computer on charge.
Install the Master-Mode Boot card in the B: slot.
Press and hold the [YES] key on the front of the computer, then press
the reset switch. The computer should "beep" seven times as it at-
tempts to boot from the B: slot.
If no beeps are heard, the batteries may be low. Check the
"
batteries.
If seven beeps are heard but the computer does nothing else,
"
release the [YES] key and press the reset switch again.
Wait for the computer to prompt for the [3] key, then press and hold
the [3] key for about 40 seconds. When done, the computer resets
and the NORAND Utilities screen or the application appears.
Remove the Master-Mode Boot card.
Reinstall any PC Card or application cards.
Close and lock the backup battery compartment door.