Replacing The Left Limit Sensor; Left Limit Sensor; Left Limit Sensor Screws - Kodak Point-of-Care CR 120 Service Manual

SERVICE GUIDE

Replacing the Left Limit Sensor

Laser Warning
To avoid possible eye damage, before operating the unit without the cover, disconnect the laser (see
the Laser" on Page 35). For additional laser precautions see
personnel may remove the cover.
[1] Remove the Main Cover (see
Left Limit Sensor Connector
[2] Disconnect the Sensor Cable from the Connector Panel.
[3] Mark the location of the sensor.

Left Limit Sensor Screws

[4] Remove the 2 screws attaching the sensor to the sensor bracket, and remove the sensor.
[5] Reverse the above steps, to install the Left Limit Sensor, using the marked location of the previous sensor.
60
"Laser Safety Instructions" on Page
"Removing the Main Cover" on Page
11. Only authorized
33).
10APR2006 – Catalog No. 6H1344
"Disconnecting