Replacing The Laser Board; Laser Board Connectors; Laser Board Screws - Kodak Point-of-Care CR 120 Service Manual

SERVICE GUIDE

Replacing the Laser Board

Laser Warning
To avoid possible eye damage, before operating the unit without the cover, disconnect the laser (see
the Laser" on Page 35). For additional laser precautions see
personnel may remove the cover.
[1] Remove the Main Cover (see

Laser Board Connectors

[2] Disconnect the cables from the Laser Board.

Laser Board Screws

[3] Remove the 3 screws securing the Laser Board, and remove the board.
[4] Reverse the above steps to install the Laser Board.
40
"Laser Safety Instructions" on Page
"Removing the Main Cover" on Page
11. Only authorized
33).
10APR2006 – Catalog No. 6H1344
"Disconnecting