Agilent Technologies E1300B User Manual page 223

Table B-2. Error Messages and Causes
Error Messages and Causes
Code Message
-101
Invalid character
- 102 Syntax error
- 103 Invalid separator
- 104 Data type error
- 108 Parameter not allowed
- 109 Missing parameter
- 113 Undefined header
- 123 Numeric overflow
- 128 Numeric data not allowed
- 131 Invalid suffix
- 138 Suffix not allowed
- 141 Invalid character data
- 178 Expression data not allowed
- 211 Trigger ignored
- 222 Data out of range
- 224 Illegal parameter value
- 240 Hardware error
- 310 System error
- 350 Too many errors
- 410 Query interrupted
- 420 Query unterminated
- 430 Query deadlocked
1500 External trigger source
already allocated
2002 Invalid logical address
2003 Invalid word address
2005 No card at logical address
2101 Failed Device
2102 Unable to combine device
2103 Config warning, Device
driver not found
2105 Config error 5, A24 memory
overflow
2108 Config error 8, Inaccessible
A24 memory
Cause
Unrecognized character in specified parameter.
Command is missing a space or comma between
parameters
Command parameter is separated by some
character other than a comma.
The wrong data type (i.e. number, character,
string expression) was used when specifying a
parameter.
Parameter specified in a command which does
not require one.
No parameter specified in the command in
which a parameter is required.
Command header was incorrectly specified.
A parameter specifies a value greater than the
command allows.
A number was specified for a parameter when a
letter is required.
Parameter suffix incorrectly specified
(e.g. .5SECOND rather than .5S or .5SEC).
Parameter suffix is specified when one is not
allowed.
The discrete parameter specified is not allowed
(e.g. TRIG:SOUR INT - INT is not a choice.)
A parameter other than the channel list is
enclosed in parentheses.
Trigger occurred while the Pacer is in the idle
state, or a trigger occurred from a source other
than the specified source.
The parameter value specified is too large or too
small.
The numeric value specified is not allowed.
Hardware error detected during power-on cycle.
Return multimeter to Agilent for repair.
If caused by *DMC, then macro memory is full.
The error queue is full as more than 30 errors
have occured.
Data is not read from the output buffer before
another command is executed.
Command which generates data not able to
finish executing due to a multimeter
configuration erorr.
Command execution cannot continue since the
mainframe's command input, and data output
buffers are full. Clearing the instrument restores
control.
"Event In" signal already allocated to another
instrument such as a Switchbox.
A value less than 0 or greater than 255 was
specified for logical address.
An odd address was specified for a 16 bit read or
write. Always use even addresses for 16 bit
(word) accesses.
A non-existent logical address was specified with
the VXI:READ? or VXI:WRITE command.
VXI device failed its self test.
Device type can not be combined into an
instrument such as a scanning voltmeter or a
switchbox.
ID of device does not match list of drivers
available. Warning only.
More A24 memory installed in the mainframe
than can be configured into the available A24
memory space.
A24 memory device overlaps memory space
reserved by the mainframe's operating system.
Error Messages B-3