Agilent Technologies E1300B User Manual page 174

SYSTem:COMMunicate :SERial[n] [:RECeive] :PARity [:TYPE]?
:COMMunicate
:SERial[n] [:RECeive]
:PARity [:TYPE]?
Example
:COMMunicate
:SERial[n] [:RECeive]
:SBITs
Parameters
Comments
Example
7-46 System Instrument Command Reference
SYSTem:COMMunicate:SERial[n][:RECeive]:PARity[:TYPE]? returns the
type of parity checked and generated.
What type of parity checking is set?
SYST:COMM:SER0:PAR?
enter statement
SYSTem:COMMunicate:SERial[n][:RECeive]:SBITs < sbits> Sets the
number of stop bits to be used to transmit and receive data.
Parameter Parameter
Name Type
sbits numeric
Attempting to set sbits to other than those values shown will result in an
error -222.
While this command operates independently of either the
PARity:TYPE commands, there are two combinations which are
disallowed because of their data frame bit width. The following table
shows the possible combinations:
BITS
7
7
7
7
8
8
8
8
DIAG:BOOT:COLD will set
Related Commands: SYST:COMM:SER[n]:BAUD
*RST Condition: No change
Configuring for 2 stop bits.
SYST:COMM:SER0:SBITS 2
ask for parity type
returns the string EVEN, ODD,
Z ERO, ONE, or NONE
Range of
Values
1| 2| MIN| MAX
PARity:TYPE SBITs
NONE 1
NONE 2
Yes 1
Yes 2
NONE 1
NONE 2
Yes 1
Yes 2
SBITs to 1.
Default
Units
none
BITS or
Frame Bits
9 - disallowed
10
10
11
10
11
11
12 - disallowed