Agilent Technologies E1300B User Manual page 176

SYSTem:COMMunicate :SERial[n]:TRANsmit :PACE [:PROTocol]
:COMMunicate
:SERial[n]:TRANsmit
:PACE [:PROTocol]
Parameters
Comments
Example
:COMMunicate
:SERial[n] :TRANsmit
:PACE [:PROTocol]?
Example
:DATE
Parameters
Comments
7-48 System Instrument Command Reference
SYSTem:COMMunicate:SERial[n]:TRANsmit:PACE[:PROTocol]
< protocol> enables or disables the transmit pacing (XON/XOFF) protocol.
Parameter Parameter
Name Type
protocol discrete
For an Agilent E1324A, AUTO is always ON. In this case
TRAN:PACE will also set
Receipt of an XOFF character (ASCII 19
transmission of data until an XON character (ASCII 17
received.
DIAG:BOOT:COLD will set
Related Commands: SYST:COMM:SER[n]:TRAN:AUTo
*RST Condition: No change
Set XON/XOFF transmit pacing
SYST:COMM:SER0:TRAN:PACE:PROT XON
SYSTem:COMMunicate:SERial[n]:TRANsmit:PACE[:PROTocol]? returns
the current transmit pacing protocol.
Check transmit pacing protocol
SYST:COMM:SER0:TRAN:PACE:PROT?
enter statement
SYSTem:DATE < year> ,< month> ,< day> sets the E1300/E1301
mainframe's internal calendar.
Parameter Parameter
Name Type
year numeric
month numeric
day numeric
The upper limit on the day parameter is dependent on the month
parameter and may be dependent on the year parameter in the case of a
leap year.
Range of
Values
XON| NONE
[RECeive]:PACE
, 13 ) will hold off
10 16
10
PACE to XON.
statement enters the string
"XON" or "NONE"
Range of
Values
must round to 1980 to 2079
must round to 1 to 12
must round to
1 through last day of month
Default
Units
none
, 11 ) is
16
Default
Units
none
none
none