Agilent Technologies E1300B User Manual page 147

:INTerrupt:ACTivate
Parameters
Comments
Example
:INTerrupt:SETup[n]
Parameters
Comments
DIAGnostic:INTerrupt:ACTivate < mode> enables an interrupt on the VXI
backplane interrupt line specified by DIAG:INT:SET[n] to be acknowledged.
Parameter Parameter
Name Type
mode boolean
When an interrupt occurs and has been acknowledged, the response is
read with the DIAGnostic:INTerrupt:RESPonse? command.
If an interrupt occurs on a VXIbus backplane interrupt line and the
interrupt acknowledgement has not been enabled, there is no interrupt
acknowledgement response. The interrupt will be held off until the
interrupt acknowledge is enabled by either the DIAG:INT:ACT
command or DIAG:INT:RESP? command.
ON or 1 enable interrupt acknowledgement. OFF or 0 disables interrupt
acknowledgement.
Bit 8 in the Operation Status register can be used to indicate when an
interrupt has been acknowledged. See chapter 6 for more details about
this register.
Interrupt acknowledgement must be re-enabled every time an interrupt is
acknowledged
Related Commands: DIAG:INT:PRIority[n], DIAG:INT:RESP?,
DIAG:INT:SET[n]
*RST Condition: DIAG:INT:ACTivate OFF (for all lines)
Enable an Interrupt Acknowledgement on Line 2.
DIAG:INT:SET2
DIAG:INT:ACT ON
DIAGnostic:INTerrupt:SETup[n] < mode> specifies that an interrupt on VXI
backplane interrupt line [n] will be serviced by the System Instrument service
routine (DIAGnostic:INTerrupt commands) rather than the operating system
service routine.
Parameter Parameter
Name Type
mode boolean
SETup1 through
Sending SETup without an [n] value specifies VXI interrupt line 1.
DIAGnostic :INTerrupt:ACTivate
Range of
Values
0| 1| OFF| ON
Set up interrupt line 2
Enable interrupt to be
acknowledged
Range of
Values
0| 1| OFF| ON
SETup7 specify the VXI interrupt lines 1 through 7.
System Instrument Command Reference 7-19
Default
Units
none
Default
Units
none