EA Technology UltraTEV Monitor Operating Manual page 53

EA Technology
Figure 40: Configured Alarms
There are a few actions that can be performed on each alarm, detailed below:
Edit Alarm – Edit the alarm settings.
Copy Alarm – Copy the selected alarm to different channels.
Delete Alarm – Deletes the selected alarm.
To create a new alarm, click on Create New Alarm. The screen in Figure 4141 will then be shown.
All the fields are required to be entered for a new alarm; the following table details their meaning:
Is Active Determines if the alarm is active or not. Setting this to no will mean that the
alarm will not activate if the alarm criteria is met.
Category Choose between red or amber. This denotes the severity of the alarm.
Type Select the measurement point that you want to set an alarm against.
Threshold The value by which the measurement point must be over for the alarm to
activate.
Span Mode There are different modes by which the alarm criteria can be measured. For
this option, select Sample Value.
Figure 41: Creating a new alarm
Figure 422 shows the screen for copying alarms. This enables you to copy an alarm created for one
channel to other similar channels. Pick the channels in the left window that you wish to copy the
selected alarm to. Move these channels to the right-hand window and click on Copy to copy to these
channels.
UltraTEV Monitor Operating Manual
TM
50
2178L014