Hub Unit Controls - EA Technology UltraTEV Monitor Operating Manual

EA Technology
The Monitor Hub may be shut down by one of the following two procedures.
3. If a remote connection can be established with the Monitor Hub then the procedures
detailed in Section 17 should be followed.
4. Alternatively the user may manually force the Hub into a shutdown state by pressing the
Reset Button, see table below.
The following table details the button actions:-
Hub Unit state
ON
Table 2: Reset button functionality
The Hub Unit is equipped with an auto-start system that will switch the Monitor
on automatically if mains power is connected to the Power Supply. If the Monitor
is required to be switched off for any length of time, mains power should be
disconnected after shutting down the Monitor.

3.8.4 Hub Unit Controls

The Hub Unit is controlled via a web-based user interface. For details on how to connect, please refer
to chapter 10.1, Connecting to the UltraTEV Monitor.
The Monitor is designed to be switched on and running all the time. It can be shut down from the
web interface, and will restart while it is plugged in to the mains. However, should the web interface
be unavailable, the Hub Unit is equipped with a reset button that is accessible as shown in Figure
10.
UltraTEV Monitor Operating Manual
TM
Procedure
Short 1s press
Long 10s press
Long 10s press, 1s no press, 1s
press
21
Function
Sends the signal to shut down
and then auto restart the
Monitor. In order to power off
the monitor permanently, the
mains power must be
disconnected while the unit is
shutdown, before it restarts.
Once the Health LED goes out
completely, power can be
safely removed.
Force switch off. Apply only if
1s press did not work.
Reset – Unit is forced to switch
off and then restarted. Apply
only if 1s press did not work.
2178L014