Adjusting The Quick-Release Axle; Adjusting The Handrims - Otto Bock Start M4 XXL Instructions For Use Manual

Settings
3

6.2.3 Adjusting the quick-release axle

The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the quick-release axle by the head (wrench size: 19 mm) and by the tip (wrench size: 11 mm) with a ring
and open-ended wrench respectively.
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 5, item 1) in or out.
5

6.2.4 Adjusting the handrims

INFORMATION
This section does not apply to standard wheels.
All handrims are designed for a spacing from the drive wheel of 15 mm (standard setting) and 25 mm.
1) Completely remove the tyre.
2) Loosen/remove the handrim screw connection from the rim (see fig. 7).
3) Tightly screw the handrims onto the rim in narrow or wide installation position.
4) Completely reinstall the tyre.
6
12
4
7
Start M4 XXL, Start M6 Junior