Table of Contents
Advertisement
Preparation for use
•
Options according to the order
•
Instructions for use
The seat cushion is not included in the standard package.
5.2 Storage
5.2.1 Storage during daily use
The wheelchair must be stored in a dry place.
5.2.2 Storage during extended disuse
The wheelchair must be stored in a dry place. During longer storage periods, an ambient temperature between
-10 °C and +40 °C must be maintained.
It is not necessary to disassemble or fold up the wheelchair.
During extended storage, the knee lever wheel lock on wheelchairs with PU tyres (= tubeless tyres) must be
released since tyre deformation may otherwise result.
Tyres contain chemical substances that can react with other chemical substances (such as cleaning agents, acids,
etc.).
6 Preparation for use
6.1 Assembly
CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding the wheelchair out or together, only grip by the specified components.
CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of qualified personnel.
► After every assembly, check for proper mounting of the drive wheels. The quick-release axles must be
securely locked in the receiver bushings.
► Pay particular attention to the stability against tipping, free running of the drive wheels and correct function of
the brakes/wheel locks.
INFORMATION
On the topic of disassembly/transport: see Page 32.
It only takes a few simple steps to prepare the wheelchair for use:
1) Attach the drive wheels to the receiver bushings (see fig. 2):
→ Press the button on the quick-release axle.
→ Attach the drive wheel to the receiver bushing and release the button on the quick-release axle.
→ The quick-release axles must not be removable after releasing the push-button.
2) Unfold the wheelchair (see fig. 3; see fig. 5).
3) Attach the leg supports (see Page 21).
4) If necessary: Attach the flap of the back support upholstery to the seat with the hook-and-loop fastener (see
fig. 4).
5) If necessary: Fit the seat cushion (see Page 24).
12
Start B2
Advertisement
Table of Contents
