Installation - Yamaha VK540EF Service Manual

OIL PUMP, CRANKCASE AND CRANKSHAFT
ESS00169

INSTALLATION

1. Install:
S Stopper rings 1
(onto the lower crankcase bearing as shown)
2 Knock pin
A Lower crankcase
B Upper crankcase
2. Install:
S Crankshaft assembly
(to upper crankcase)
NOTE:
Set the knock pins 1 on the upper crankcase
and labyrinth seal into the pin holes 2 of the
bearings and upper crankcase by turning the
bearings and labyrinth seal. At the same time,
align the bearing punched marks 3 with the
crankcase mating surface 4 .
CAUTION:
The oil seal lip must fit into the crankcase
groove.
CAUTION:
Before installing and torquing the crank-
case bolts, be sure to check that the crank-
shaft turns smoothly.
3. Tighten:
S Crankcase bolts 1 X
NOTE:
Tighten the bolts in order, starting with the low-
est number, and torque the bolts in two stages.
Bolt (crankcase) 1 X
1st:
13 Nm (1.3 mSkg, 9.4 ftSlb)
2nd:
21 Nm (2.1 mSkg, 15 ftSlb)
5-18
ENG
10 (M8)
:
10