Table of Contents
Advertisement
82
ASSEMBLY INSTRUCTIONS
A When connecting, be careful not to interfere the brake
link.
C Boom section
1. Install tubes to the boom and install the hydraulic
hoses to the tubes.
(1) Hydraulic hose mid-1 (with male coupler) (3/4-UNF)
(2) Hydraulic hose mid-2 (with female coupler) (3/4-UNF)
(3) 2-Tubes
(4) 2-Tube stays
(5) 2-M8 x 35 bolts
2-Collars
2. Remove the M8 bolts from the cover.
Using the M8 bolts contained in the kit, secure the stay
(provided with the hydraulic hose joint) and the cover
together in position.
3. Connect the hydraulic hose hitch 1 and hydraulic hose
hitch 2 between the pipe and hitch stay assembly.
(1) Hydraulic hose hitch-1
(2) hydraulic hose hitch-2
(3) 2-M8 x 40 bolts
(4) Stay
(5) Cover
4. Connect the hydraulic hoses to the coupler stay assy.
(1) Hydraulic hose mid-1 (with male coupler)
(2) Hydraulic hose mid-2 (with female coupler)
(3) Coupler stay assy
C Controller section
1. Remove the lever boot first and then the lever.
(1) Lever boot
(2) Control lever
2. Cut the lever boot as shown below.
(1) Lever boot
(A) 15 mm (0.6 in.)
Advertisement
Table of Contents
