Table of Contents
Advertisement
A Make sure valve color mark, connector assembly cap
color and hose color band are matching.
A With all the hoses connected to the valve, be certain
that any of the hoses is out of close contact with the
other hoses, the fittings and edges.
A If the above problem is found, correct the hoses to
remove their twist by loosing the nut shown in the
figure and readjusting the fitting angle for avoiding
such close contact.
(1) Fitting
(2) Nut
A To prevent hose twisting both of hose ends are
connecting to adapter first then tighten.
C Controller stand section
1. Remove the cover of the tractor.
ASSEMBLY INSTRUCTIONS
(1) 2-Rivets
(2) 3-Bolts with washers (with cap)
(3) Flange bolt
(4) Plain washer
(5) Console cover
A At the time of removing the rivets, use screw driver to
loosen the screw then pull the rivets out.
2. Remove the holder.
(1) Holder
15
Advertisement
Table of Contents
