Kubota LA1154A Assembly Instructions Manual page 65

4. Pass the lever boot through the 3rd function control
lever.
A Pass the harness through the boot.
A If the harness is difficult to go through the boot, apply
a small amount of grease on the inside of the lever
boot in advance, pass it carefully through the boot and
finally wipe off the grease.
(1) Lever boot
(2) 3rd function control lever
5. Install the 3rd function control lever as shown below,
and secure it with the nut.
(1) 3rd function control lever
(2) M14 nut
(A) Parallel
ASSEMBLY INSTRUCTIONS
6. Remove the plug from the console. Remove the
plastic fastener from the 3rd function on/off switch, and
attach the switch onto the console.
(1) Console
(2) Plug
(3) Switch
A When removing the plastic fastener from the switch,
remain the rubber ring on the switch.
(1) Switch
(2) Plastic fastener
(3) Rubber ring
63