Table of Contents
Advertisement
5. Tighten up the lock nuts at both sides of the valve stay
to secure the cables in place.
(1) 6-M16 lock nuts
Tightening Torque
A When assembling the switch section, keeping the self-
level on/off lever downward.
A With the lock nuts tight in position, move the lever to
make sure that the cables and spools behave
smoothly as specified.
6. Check the position of the valve spool for self-leveling
relative to the lever position. If it is not following the
figures below, reconfigure the cable assembling
process.
[Lower position (self-leveling is on)]
60.0 to 80.0 N-m
(6.1 to 8.2 kgf-m)
(44.3 to 59.0 ft-lbs)
ASSEMBLY INSTRUCTIONS
[Upper position (self-leveling is off)]
(1) Self-level on/off lever
(Lower position)
(2) Self-level on/off lever
(Upper position)
(3) Spool for self-leveling
C Control valve cover section
1. Attach the valve cover to the valve stay.
(1) Valve cover
(2) 3-M8 x 20 bolts with washers
A In case the hydraulic hose contacts the valve cover,
readjust the angle of hose.
29
(A) Spool length is same
(B) Spool length is shorter
than others
Advertisement
Table of Contents
