Table of Contents
Advertisement
42
ASSEMBLY INSTRUCTIONS
[M7999 (CAB MODEL)]
(A) "FRONT"
(B) "SIDE"
6. Set the lock lever on the cable controller to the neutral
position.
A Control lever should be neutral and be locked with lock
lever.
[M7998 (ROPS MODEL)]
[M7999 (CAB MODEL)]
(1) Lock lever
(A) "LOCK"
(B)
"UNLOCK"
7. Install one lock nut to each cable end. Then route the
cable ends through the valve stay.
(1) Cable (Blue, Boom section)
(2) Cable (Red, Bucket section)
(3) Cable (Gray, Switch section)
(4) 3-M16 lock nuts
(5) Valve stay
(6) Spool (Boom section)
(7) Spool (Bucket section)
(8) Spool (Switch section)
A Check the spool position at first. Distance from center
of the spool holes to end surface of the valve must be
same length as other spools.
A When assembling the switch section, keeping the self-
level on/off lever downward.
A The cable with blue tape is for boom section and the
cable with red tape is for bucket section and the cable
with gray tape is for switch section.
(A) For switch section
(B) Same length (30 mm (1.2 in.))
Advertisement
Table of Contents
