Installing Cisco IP/TV 3425 and 3425A Server Units
Connecting Power and Booting the System
Step 1
Step 2
Step 3
Figure 3-8
Cisco IP/TV 3425 and 3425A Servers—Rear View
Power switch
Power receptacle
Cisco IP/TV 3400 Series Servers User Guide
3-8
To connect AC power to the IP/TV Server, follow these steps:
Plug the AC power cord into the power cord receptacle on the back of the IP/TV
Server. (See
Figure
3-8.)
Connect the other end of the power cord to a power source at your installation site.
Power on the device.
The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See
Configuration
Parameters.")
Chapter 3
Chapter 4, "Setting IP/TV Server
Installing the IP/TV Server
OL-4467-01