Installing Cisco Ip/Tv 3426 Broadcast Server Units; Rack Requirements - Cisco IP/TV 3400 Series User Manual

Chapter 3 Installing the IP/TV Server

Installing Cisco IP/TV 3426 Broadcast Server Units

Rack Requirements

OL-4467-01
Place the unit in the desired location. You can mount the IP/TV Server unit in a
rack for your convenience, or place it on a solid, stable surface. If you do not plan
to install the IP/TV Server in an equipment rack, proceed to the
IP/TV Server on a Tabletop" section on page
This section discusses the following topics:
Rack Requirements
•
Tools and Parts Required
•
Installing the Chassis in the Rack
•
Connecting Cables
•
Connecting Power and Booting the System
•
Install your IP/TV Server in a rack that meets the following requirements:
Four posts, 19 inches (48.3 cm) wide
•
Minimum depth of 28.27 inches (71.8 cm) and maximum depth of 30 inches
•
(76.2 cm) between the front and rear mounting flanges
Minimum depth of 2.76 inches (7.0 cm) between the front mounting flange
•
and inside of the front door (for cabinet-style racks)
Minimum depth of 6.18 inches (15.7 cm) between the rear mounting flange
•
and inside of the rear door (for cabinet-style racks)
Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.

Installing Cisco IP/TV 3426 Broadcast Server Units

3-30.
Cisco IP/TV 3400 Series Servers User Guide
"Installing the
3-9