Connecting Power And Booting The System - Cisco IP/TV 3400 Series User Manual

Chapter 3 Installing the IP/TV Server
1
Keyboard port
2 Onboard video port
3 Serial port
4
Mouse port
4
5 PCI slots 1 and 2 (Winnov Videum 1010 Plus
video capture cards)
6 PCI slots 3 (Winnov Videum 4400 AV video
capture card), 4, and 5 (Optibase MovieMaker
200S Networker video capture cards)
7
AC power receptacles
1. SCSI = Small Computer System Interface
2. USB = Universal Serial Bus
3. ISMP = Integrated System Management Processor
4. PCI = Peripheral Component Interconnect
Step 2
Step 3
Step 4
Step 5

Connecting Power and Booting the System

Step 1
Step 2
OL-4467-01
Connect the other end of the network cable to a hub or switch in your network.
For monitor connections, plug the monitor cable into the onboard video port on
the IP/TV Server back panel. (See
Connect the other end of the monitor cable to a monitor.
Plug the keyboard and mouse cables to the keyboard port and mouse port,
respectively. (See Figure
To connect power to your system, follow these steps:
Review the information in the
Plug a power cord into each power cord receptacle on the back of the IP/TV
Server. (See Figure 3-23.)
Installing Cisco IP/TV 3427 Broadcast Server Units
1
8
SCSI connector
2
9 USB 2 (not supported
10 USB 1 (not supported)
3
11 ISMP
port (not supported)
12 ISMP port (not supported)
13 Ethernet 2
14 Ethernet 1
Figure 3-23.)
3-23.)
"Safety Guidelines" section on page
Cisco IP/TV 3400 Series Servers User Guide
2-4.
3-29