Installing The Ip/Tv Server On A Tabletop - Cisco IP/TV 3400 Series User Manual

Installing the IP/TV Server on a Tabletop

Step 3
Step 4
Step 5

Installing the IP/TV Server on a Tabletop

Cisco IP/TV 3400 Series Servers User Guide
3-30
You must connect a power cord to both power supplies. If only one power
Note
supply is connected, when you turn on the power, the system error LED
comes on and the system makes a loud noise.
Connect the other end of each power cord to a power source at your
installation site.
Power up all externally connected devices.
Press the power control button on the front of the IP/TV Server.
The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See
Configuration Parameters.")
While the IP/TV Server is powering up, the green power on LED on the
Note
front of the IP/TV Server is on.
When you install an IP/TV Server on a workbench or tabletop, ensure that the
surface is clean and in a safe location and that you have considered the following
points:
The chassis should be installed off the floor. (Dust that accumulates on the
•
floor is drawn into the interior of the chassis by the cooling fans. Excessive
dust inside the IP/TV Server can cause overtemperature conditions and
component failures.)
• There must be approximately 19 inches (48.26 cm) of clearance at the front
and rear of the chassis for accessing network cables or equipment.
The IP/TV Server must receive adequate ventilation (do not install it in an
•
enclosed cabinet where ventilation is inadequate).
Chapter 3
Chapter 4, "Setting IP/TV Server
Installing the IP/TV Server
OL-4467-01