Table of Contents
Advertisement
Installation
Install Battery Holder
The batteries that power the receiver and handset need
to be installed prior to pairing and use.
1. Take the receiver out from under the fi rebox.
2. Insert four 1.5 V high quality alkaline batteries in
the battery holder supplied with the appliance and
one high quality alkaline 9 V battery in the remote
handset.
3. Connect the battery holder cable supplied with the
appliance to the receiver as shown.
4. Connect the other end of the cable to the battery
holder.
Install Battery Holder
5. Place the receiver and battery holder as shown un-
der the fi rebox. Placement may vary with installed
options.
Receiver
Battery holder
6. Use a heat-resistant tie to gather any extra cable
between the receiver and the holder.
Caution
DO NOT let the cable touch the burner plate
above, it will melt during operation.
Caution
Do not put batteries in the receiver as leaking acid
could damage its circuit board.
33
Advertisement
Table of Contents
