Table of Contents
Advertisement
Note 1: Connector: Deutsch HD N 36 - 24-19 SN - 059
Terminals: Size 12 (large): Deutsch 0462-203-12141
Size 16 (small): Deutsch 0462-201-16141
Unused cavities to be sealed with: Deutsch 114017
Note 2: Connector: Deutsch HD N 34 - 24-19 PN - 059
Terminals: Size 12 (large): Deutsch 0460-202-12141
Size 16 (small): Deutsch 0460-202-16141
Nut:
Deutsch 112263-90
Lockwasher: Deutsch 112264
Unused cavities shall be sealed with: Deutsch 114017
Note 3: Connector: AMP 776241-1
Terminals: Deutsch 0462-209-16141
Unused cavities shall be sealed with: Deutsch 114017
Note 4: Connector: Packard 1212 4634
Terminals: Packard 1207 7413
Wire seal:
Packard 1201 0293
Note 5: Connector: Deutsch DT 04-2P
Terminals: Deutsch 1060-14-0122
Wedge:
Deutsch W2P
Note 6: Temperature switch, KIM HOTSTART nr: DIT 810. (1/2" NPT)
Delivered with 3 feet 16-3 cord attached.
Middle wire (ground) is separately insulated.
Residual insulation from wire separation on wire ends shall be
removed before splicing.
Note 7: Connector: G&H 17984.000.001 (DIN 72585 - 4 pins)
Terminals:G&H 26570.201.184
Wire seal:G&H 14414.627.626
Unused cavities to be sealed with:G&H 14416.627.646
Wiring braided until connector, and attached to strain relief with
nylon strap.
Note 8: Connector: AMP 0-963040-3
Terminals: AMP 0-929939-1
Wire seal:
AMP 828904-1
Seal grommet:Bosch 1280 703 26026
Note 9: Connector: Deutsch DTM 06-2S
Terminals: Deutsch 1062-20-01221
Wedge:
Deutsch WM 2S
Note 10:Relay socket:Bosch 3334485008
Terminals: AMP 6-160448-2
Note 11:Connector: Deutsch DRC 16-40S
Terminals: Deutsch 0462-201-16141
Unused cavities to be sealed with: Deutsch 11407
Note 12:Connector: Deutsch DRC 16-24S
Terminals: Deutsch 0462-201-16141
Unused cavities to be sealed with: Deutsch 11407
Note 13:Connector: Deutsch DRC 16-24SB
Terminals: Deutsch 0462-201-16141
Unused cavities to be sealed with: Deutsch 11407
Note 14:Connector: White products nr: WHT 1616 (moulded on wire)
Note 15:Connector with 4 feet 16-3 cord attached.
Delivered with KIM HOTSTART glowplugs nrs: OW650100-000
or OW650200-000.
No KIM HOTSTART partnumber available, contact MFI
department for delivery agreements.
Middle wire (ground) is separately insulated.
Power supply plug shall be removed.
Residual insulation from wire separation on wire ends shall be
removed before splicing.
Note 16:Connector: Packard 1530 0027
Terminals: Packard 1207 7412
Wire seals: Packard 1201 5323
Sec. lock:
Packard 1530 0014
Note 17:Connector with 6 feet 16-3 cord attached.
Delivered with KIM HOTSTART glowplugs
nrs: TF101-000-WOC or TF102-000-WOC.
Middle wire (ground) is separately insulated.
Power supply plug shall be removed.
Residual insulation from wire separation on wire ends shall be
removed before splicing.
Note 18:AMP 133544-4
Shrinkable sleeve to be attached as in drawing.
Wall thickness: min. 1 mm.
Wires may be devided over two terminals if necessary.
1
5
1: Braiding
2: Insulated wires
3: Terminal
4: Non-insulated wires
5: Sleeve
Note 19:Connector: Deutsch DT 06-2S
Terminals: Deutsch 0460-201-16141
Wedge:
Deutsch W 2S
Note 20:In order to fix wire 17 it will go into the braided part of the harness
and once around the wires in the main branch before returning.
Note 21:This part of the harness should be resistant to temperatures up to
105 °C.
Note 22:Wire insulation should be resistant to oil, fuel and coolant.
Note 23:Terminals shall be equipped with a label with printing: "ALWAYS
INSULATE WIRE". Label and printing must be water, oil, coolant
and diesel resistant. Terminals shall be equipped with a shrinkable
sleeve with a layer of glue, as in drawing below, and strapped to the
harness with nylon straps.
6: Wire
7: Sleeve
8: Squeezed tight when hot
Note 31:Connector: Deutsch DT 06-3S-EP11
Terminals: Deutsch 0462-201-16141
Secondary lock: Deutsch W3P-1939
Note 32:Connector: Deutsch DT 04-3P-P006
Secondary lock: Deutsch W3S-1939
Plugged into connector of note 31
Note 33:Connector: Deutsch HD 14-9-96-P
Terminals:Deutsch 0460-202-16141
Unused cavities to be sealed with: Deutsch 114017
Protective cover: HDC 16-9
Protective cover fixed to harness with a wire
Both ends of the wire run at least 200 mm into the wire harness
Note 40:Connector: Deutsch DT 06-3S-EP11
Terminals:Deutsch 0462-201-16141
Unused cavities to be sealed with: Deutsch 11407
Secondary lock: Deutsch W3S
Note 50:Wiring from tree to CAT diagnostic
To be protected by Shrinkhose
Note 51:Protection cap: WHITE n° 02-06-001549
ORIENTATION AS STATED BELOW
Harness to be fixed on the protection cap.
1604 7429 03-5
Wiring diagram
2
4
3
7.5
7.5
7.5
7.5
6
7
8
67
Advertisement
Table of Contents
