Table of Contents
Advertisement
Air Discharge Temperature Control parameter
"Disable"
When the parameter is disable or disable lock, the PID will regulate
the Air Discharge Temperature to a fixed value of 4°C to prevent
freezing.
The CCM will run through the standard Warmup procedure, with
the valve closed.
Air Discharge Temperature Control parameter "Enable"
When the parameter is enable or enable lock, the PID will regulate
the Air Discharge Temperature to the Air Discharge Temperature
Setting.
After starting the compressor, the CCM will first run through the
Temperature Control Warmup procedure in the Warmup status.
This procedure will override the standard Warmup procedure and
settings.
When the engine started, the CCM executes following Warmup
procedure if the Air Discharge Control Parameter is Enable (lock);
If the Coolant Water Temperature is at 50°C or above, the Warmup
procedure is ended.
When the Warmup procedure has ended, the CCM can go to the
Not Loaded status, or to the Load/Unload status.
Barometric Calibration
For applications running in low barometric pressure environments
(high altitude), Caterpillar compensates the diesel injection.
Preliminary
4
Operating instructions
4.1 Parking, transporting and lifting
instruction
The operator is expected to apply all relevant safety
!
precautions, including those mentioned on the pages
7-10 of this book.
4.1.1
Parking instructions
Locate the wind direction and place the rear end of the unit upwind,
away from contaminated wind streams and walls. Avoid
recirculation of exhaust air from the engine. This causes
overheating and engine power decrease.
Park the unit on solid level ground. Engage the parking brake by
pulling parking brake handle (1) and place wheel chocks in front of
and behind the wheels before the unit is disconnected from the
towing or lifting vehicle.
3
Lock the towbar (2) in the raised position with catcher (3).
Instruction manual
2
1
27
Advertisement
Table of Contents
