Consult the preventive maintenance schedule (section 5.1) for
replacing intervals.
Drain condensate from the primary fuel filters (water separators)
regularly by loosening the drain plugs (4). Catch the condensate in
a drain pan. Tighten the plugs after draining.
5.6.2
C18 electrical fuel priming pump
instruction
– Switch unit ON
– Place the end of the transparent fuel hose in a suitable container to
catch fuel when priming
– Turn yellow valve (a) on priming pump to the open position
– Activate the priming pump by switching (b) to the ON position
– Switch off (b) when fuel appears in the transparent hose
– Close valve (a) and drain fluid left in transparent hose
– Start the engine and initiate a test run
If pump does not start when switch (b) is activated,
!
check fuse in CCM fuse box
Preliminary
3
5.6.3
Cleaning fuel tanks
2
To drain sediment and water from the fuel tanks (1), remove the
drain plug (2) of both fuel tanks and frame.
For a better drainage slightly slope the unit.
Use water to clean the inside of the fuel tanks, use a high-pressure
purifier if necessary. Spurt the sediment and water to the drain side
of the tank.
After cleaning or heavy rains, drain the spillage-free
!
frame.
5.7 Cleaning coolers
Keep all coolers clean to maintain the cooling efficiency.
The fan side surface of the radiator, intercooler, aftercooler 1 and
oil cooler is accessible by opening the service doors.
The CAC/fuel cooler and aftercooler 2 are located at the rear end of
the unit, under the air filters.
Remove any dirt from the coolers with a fibre brush. Never use a
wire brush or metal objects. Then clean by air jet in reverse
direction of normal flow.
If the dirt is oily, wash the coolers with fuel or a cleansing agent.
Protect the electrical and controlling equipment, air
!
filters, etc. against penetration of moisture.
A spray gun should preferably be used to apply the solvent to the
cooler block. Rinse the block by means of a water jet after a
soaking-in period. Steam-cleaning may also be applied.
Close the service doors.
Do not leave liquids behind.
Instruction manual
1
45