Table of Contents
Advertisement
Restarting before the parameter is back within its limits is
impossible, because of the parameter check in the cranking
procedure.
Emergency stop
When an emergency stop button is hit, this message appears on the
screen.
Until the emergency stop button is reset, the operator cannot do
anything.
When the emergency stop button is reset, the operator can proceed
to the Ready for Start status or to the Process Info status.
Warnings
When a warning is generated, the warning will appear on the screen
of the UI, and the user is prompted to a malfunction or a potential
shutdown.
There are two kinds of warnings: Process warnings and Apparatus
warnings.
– Process warnings do not have any effect on the CCM's operation.
They are generated when a measured value has exceeded its limits.
These Process warnings are: fuel level warning, engine oil level
warning, compressor oil level warning and discharge temperature
warning.
– During operation, all sensors, some outputs and the communication
lines are continuously checked for failures. When such a failure
occurs, the CCM will generate an Apparatus warning. Some errors
can cause the CCM to go to the Shutdown status (if running) or to
the Start Failure status (if in Permissive Start status).
Apparatus warnings
Fuel Level Sensor
Air Discharge Pressure Sensor
Compressor Oil Pressure Sensor
LP Element Temperature Sensor
MP Element Temperature Sensor
Loading Valve Output
ECM Communication Link
CAN Communication Link
Starter Relay
Compressor Intercooler Pressure 1 Sensor
Compressor Intercooler Pressure 2 Sensor
Compressor Oil Temperature Sensor
Air Discharge Temperature Sensor
Air Inlet Temperature Sensor
Oil Level Maintainer Valve Output
Flasher Lights Output
Horn Output
Blow-off Valve Output
EEPROM
Default Mode
Preliminary
Process warnings
Fuel Level
Engine Oil Level Too Low
Engine Oil Overfill
LP Element Temperature
MP Element Temperature
Fuel Level
Engine Oil Level Low
Air Discharge Temperature
Autostart Pressure higher than Setpressure
Battery Voltage Low
Battery Not Charging
Engine warnings
Engine Coolant Level Sensor Failure
Engine Coolant Temp. Sensor Failure
Engine Oil Temperature Sensor Failure
Engine Fuel Temperature Sensor Failure
Engine Air Inlet Temp. Sensor Failure
Engine Turbo Boost Press. Sensor Failure
Engine Oil Pressure Sensor Failure
Engine Fuel Pressure Sensor Failure
Engine Coolant Level Low
Engine Coolant Temperature Too High
Engine Air Inlet Temperature High
Engine Oil Pressure Too Low
Turbo Boost Pressure High
Engine Fuel Pressure Too Low
Engine Injector X Failure
Fuel Temperature Too High
Engine RPM Sensor Failure
*Note: See "Cooling down" on page 24.
Effect
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Instruction manual
Effect
Shutdown
Shutdown
Shutdown
Shutdown
Shutdown
Warning
Warning
Warning
Warning
Warning
Warning
Effect
Shutdown
Shutdown
Warning
Shutdown
Warning
Warning
Shutdown
Shutdown
Shutdown
Cooldown*
Warning
Shutdown
Warning
Shutdown
Shutdown
Shutdown
Shutdown
25
Advertisement
Table of Contents
