Loading And Activating A Service Control Application; Monitoring The System - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Loading and Activating a Service Control Application

To set the link mode:
From the SCE 2000 (config if)# prompt, type link-mode [<link>|all-links]
[forwarding|bypass|sniffing|cutoff] and press Enter.

Monitoring the System

Use the following commands to view the current connection mode and link mode parameters.
To view the current connection mode:
From the SCE 2000
and press
To view the current link mode:
From the SCE 2000
Enter
To view the current link mappings:
From the SCE 2000
connected-links and press
Loading and Activating a Service Control Application
The SCE 2000 platform provides the basic functionalities of Service Control analysis and
enforcement. A Service Control solution requires that a Service Control application be loaded into
the platform, to take advantage of the unique SCE platform capabilities.
Loading and activating an application includes the following stages:
Cisco SCE 2000 4xGBE Installation and Configuration Guide
6-14
prompt, type show interface linecard 0 connection-mode
#
.
Enter
prompt, type show interface linecard 0 link mode and press
#
.
prompt, type show interface linecard 0 physically-
#
Downloading the application provided as an SLI file to the SCE 2000 disk.
•
Activating the application.
•
Configuring the application.
•
Chapter 6 Cabling the Line Ports and Completing the Installation
.
Enter
OL-7824-04