Table of Contents
Advertisement
®
EXULUS
Spatial Light Modulators
Chapter 4 Setup and Software Operation
4.1.
Installing the SLM
High voltage inside. To avoid electrical shock, before powering up, make sure
that the ground pin of the power cord is correctly connected to the ground
connector in the power socket. Improper grounding can cause electric shock
resulting in severe injury or even death. Do not operate without the cover
This unit must not be operated in explosive environments.
Transportation and delivery may cause the SLM to be warm or cool
upon receipt. Please wait for the whole device to reach room
Do not operate in wet/damp conditions. Do not obstruct the air
To operate your SLM properly, place it on your lab table. For standard SLMs, two
tapped holes are available for mounting on either the side or the bottom, as shown
in Figure 24.
Page 14
SHOCK WARNING
temperature before attempting to operate.
ventilation slots in the housing!
Chapter 4: Setup and Software Operation
installed.
WARNING
WARNING
WARNING
CTN013676-D02
Advertisement
Table of Contents
Need help?
Do you have a question about the EXULUS-HD2 and is the answer not in the manual?
Questions and answers