Installing An Internal Backup Device; Installation Location Of Internal Backup Device - Fujitsu PRIMERGY RX300 S3 User Manual

Chapter 7 Installing Internal Options
7.7 Installing an Internal Backup
Device
Internal backup device can be installed in a 3.5 inch storage bay.

7.7.1 Installation Location of Internal Backup Device

Install the internal backup device in 3.5-inch storage bays 2 and 3.
3.5-inch storage bay 2, 3
Bay1
A SCSI card (PG-1301L or PG-1281) is required for installing the internal backup device.
The maximum number of internal hard disk units that can be installed becomes four, since the internal
backup device is installed in the 3.5-inch storage bay.
208
• Before installing the internal backup device, turn off the server and all
peripheral devices, and unplug the power cables from the outlet. Failure to do
so may cause electric shock ( "1.4.3 Turning Off the Server" (pg.33)).
• The circuit boards and soldered parts of internal options are exposed and can
be damaged by static electricity.
Before handling them, first touch a metal part of the server to discharge static
electricity.
• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas
or the edges of the circuit boards.