Fujitsu PRIMERGY RX300 S3 User Manual page 237

Item
USB Host Controller
USB 2.0 Host Controller
USB BIOS Supported
Devices
USB Boot Delay
USB BIOS Hot-Plug
ATA Controller Config
Diskette Controller
Mouse Controller
Onboard Video
SAS Controller
SAS Option ROM Scan
RAID
LAN Controller
LAN Remote Boot
LAN Remote Boot Ch.B
Management LAN
■ The ATA Controller Config Submenu
Sets the Serial ATA.
Item
S_ATA Mode
Primary IDE Channel
Tertiary IDE Channel
Quaternary IDE Channel
table: Items on the Peripheral Configuration Submenu
Setting
Enabled (Unchangeable)
Enabled (Unchangeable)
Auto (Unchangeable)
0 sec. (Unchangeable)
Enabled (Unchangeable)
Configures additional settings.
■
" The ATA Controller Config Submenu" (pg.237)
Enabled (Unchangeable)
Auto Detect
(Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
Channel A & B
(Unchangeable)
• Disabled (Initial value)
• PXE
Enabled (Unchangeable)
table: Items on the ATA Controller Configuration Submenu
Setting
Native (Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
Enabled (Unchangeable)
PRIMERGY RX300 S3 User's Guide
Description
Sets whether or not to use the USB controller (2.0
or 1.1 standard).
Sets which type of USB device should be used in
BIOS.
Sets the waiting time for booting from a USB
device.
Allows Hot-Plug of the USB device used for BIOS.
Sets whether or not to enable the floppy disk
controller.
Sets whether or not to use the mouse connected to
the mouse port.
Sets whether or not to enable the onboard video
controller.
Sets whether or not to enable the onboard SAS
controller.
Sets whether or not to initialize the extended ROM.
Sets whether or not to enable RAID.
Sets whether or not to enable the onboard LAN
controller (channel A, or channel A & B).
Sets whether or not the OS may be loaded from the
server. This function is used especially when no
floppy disk drive or hard disk drive are installed, or
when both are turned off.
Sets whether or not the iRMC uses LAN B. The
iRMC uses the channel B of the onboard LAN
shared with the OS.
Description
Sets the Serial ATA mode.
Sets whether or not to enable the IDE channel.
8
237