Fujitsu PRIMERGY RX300 S3 User Manual page 300

Appendix
3
When "Please enter pass phrase:" appears, enter the password and press the
[Enter] key.
Note that the password is case-sensitive. As shown below, the characters you have entered are
displayed as asterisks.
Please enter pass phrase: ******
The remote control main menu appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.**
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type
System ID
System Name
System OS
System Status: OK
Power Status : On
(1) System Information...
(2) Power Management...
(3) Enclosure Information...
(4) Service Processor...
(c) Change password
(r) Console Redirection (EMS/SAC)
(s) Start a Command Line shell...
Enter selection or (0) to quit:
4
Press the [2] key and select "Power Management".
The Power Management menu appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.**
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type
System ID
System Name
System OS
System Status: OK
Power Status : On
(1) Immediate Power Off
(2) Immediate Reset
(3) Power Cycle
(*) Power On
(*) Graceful
(*) Graceful
Enter selection or (0) to quit:
300
ID 0203 RX300S3
: PRIMERGY RX300 S3
: xxxxxxxx
: RX300S3-2 (xxx.xxx.xxx.xxx)
: xxxxxxxx
Main Menu
ID 0203 RX300S3
: PRIMERGY RX300 S3
: xxxxxxxx
: RX300S3-2 (xxx.xxx.xxx.xxx)
: xxxxxxxx
Power Management Menu
Power Off (Shutdown)
Reset (Reboot)
*
*
*
*
*
*