Raid Management Tool [Global Array Manager]; Installing Raid Management Tool (Global Array Manager) - Fujitsu PRIMERGY RX300 S3 User Manual

Chapter 6 High Reliability Tools
6.1 RAID Management Tool [Global
Array Manager]
RAID Management Tool is software that performs array configuration, disk
initialization and disk array monitoring. For more details, refer to "MegaRAID SAS
User's Guide" of the Array Controller Document & Tool CD.
OS installation using ServerStart
If the OS is installed using ServerStart, RAID Management Tool is installed with the OS and other high
reliability tools.
6.1.1 Installing RAID Management Tool (Global Array
Manager)
To Install RAID Management Tool individually using the standard installer, follow the procedures
below.
Before installing Global Array Manager, check that TCP/IP is installed and works properly.
1
Log on to the server with administrator privileges.
2
Insert the Array Controller Document & Tool CD. Click [Start] → [Run...].
3
Enter a name in the [Open:] field as follows and click [OK].
[CD-ROM drive]:\RAIDTOOL\GAM\Windows\install.bat
Installation starts and the wizard window appears.
For subsequent procedures, refer to "MegaRAID SAS User's Guide" in the Array Controller
Document & Tool CD.
●
When an error screen appears after installation (Windows Server 2003 only)
If Windows Server 2003 Service Pack 1 is applied, the following message may appear on restarting after
installing/uninstalling RAID Management Tool (Global Array Manager).
In order to protect the computer, this program is terminated by
Windows.
Name: SNMP Service
There is no problem with operations. Click [Close Message] to close the message.
174
Exit all programs before starting installation.
Installation will fail if "Event Viewer" or "Computer Management" is run.