Fujitsu PRIMERGY RX300 S3 User Manual page 267

■ Error Messages during Installation
The following error messages may appear during installation using ServerStart. Check the corrective
action against the relevant error.
●
"WzDiskAdmin: System Error! ......................, Last Error: The device is not
ready." appears.
Optional SCSI devices (e.g., hard disk cabinet, or DAT unit) may be connected. Disconnect the optional
SCSI devices and perform installation again. Connect the optional devices after the installation
completes.
●
"Operating System not found" appears when the system restarts after file
copy from the CD-ROM.
The following are possible causes. Check them.
• The array controller card comes later than the onboard SCSI array controller in order of device
startup.
• The Active flag is specified.
• The BIOS setting of the RAID card connected to the internal hard disk unit is set to [Disable]. For
details on the BIOS setting of the RAID card, refer to the user guide supplied with the RAID card.
●
"Missing Operating System" appears during installation.
The installation partition size may be too large. Specify the installation partition size correctly.
For details on the installation partition size, refer to "2.3.1 Installation Partition Size" ( pg.47).
●
"Error 1920. Service (PXE Services) failed to start" appears during
preconfigured installation.
The system installed with the preconfigured settings (PXE server) may not be connected to the network.
Check the LAN cable connection and click [Rerun].
■ An application where the tftp client function (tftp.exe) is used does
not operate properly
In the system in which Windows Server 2003 is installed, the tftp client function (tftp.exe) is not
installed by default, and the application where the tftp client function (tftp.exe) is used does not operate
properly.
To use the tftp client function (tftp.exe), install "tftp.exe" from the OS CD-ROM according to the
following procedures.
1
Insert the OS CD-ROM into the CD-ROM drive.
The OS CD-ROM must be either Windows Server 2003 CD that has applied SP1, Windows
Server 2003 x64 CD or Windows Server 2003 R2 Disc 1 CD.
2
Move to the i386 folder of CD-ROM drive.
PRIMERGY RX300 S3 User's Guide
9
267