Garage Door Opener (Homelink ® ) - Porsche 911 2020 Owner's Manual

Garage Door Opener
(HomeLink )
®
General safety instructions
Pinching, crushing or
WARNING
impact through operated
equipment
If persons or animals are in the movement area of
the operated equipment, there is a risk of injury
while the garage door opener is being operated or
programmed.
e Make sure there are no persons, animals or ob-
jects in the movement area of the operated
equipment while the HomeLink
®
operated or programmed.
e Observe the safety instructions for the original
remote control.
Operating principle
The HomeLink system, can be used to operate up to
®
eight radio-controlled devices (garage doors/prop-
erty gates, security systems, house lighting) can be
operated from the vehicle via profiles in the PCM.
> Observe the instructions for the original remote
control.
Information
For information on the compatibility of your vehicle's
HomeLink system with the original remote control:
®
e Contact an authorized Porsche dealer.
> Visit www.homelink.com or call the toll-free
hotline on 1–800–355–3515.
Information
e Before selling your vehicle, remember to delete
the garage door opener signals.
Teaching garage door opener
b b The ignition is switched on.
b b Engine is not running.
b b Vehicle is positioned to allow visual contact with
remote-controlled equipment and is within the
receiver range (signal is transmitted).
Systems with remote control
e CONTROL
1. CAR
system is being HomeLink®Garage door opener e Configure
new HomeLink® profile
2. Follow the instructions on the screen. During
programming, aim the remote control at the
overhead console from the height of the center
console.
Systems without rolling code system:
The profile is taught.
– or –
Systems with rolling code system:
The profile is created. Manual synchronization
between the HomeLink
quired to complete the teaching process:
3. Follow the instructions on the screen.
> Read and follow the instructions for the
original remote control.
The profile is taught.
Information
If the signals cannot be stored despite having care-
fully read this chapter and the operating instructions
for the original remote control:
e Contact an authorized Porsche dealer.
e Make sure that there is a new battery in the ga-
rage door opener remote control. Insufficient
battery power can cause malfunctions in signal
transmission. The system in the vehicle then
learns an incorrect code, which cannot be reliably
recognized.
e Check the compatibility of the vehicle's
HomeLink
control.
e Vehicle e
Systems without remote control (FixKit
receiver)
1. CAR
HomeLink®Garage door opener e Configure
new HomeLink® profile e
2. Select the desired option.
3. Follow the instructions on the screen.
The profile is taught.
and vehicle is still re-
®
Using the garage door opener
Calling up configured HomeLink
manually
b b Ignition is switched on.
b b Vehicle is positioned to allow visual contact with
remote-controlled equipment and is within the
receiver range (signal is transmitted).
1. CAR
2. Select the desired profile.
Garage Door Opener (HomeLink
system with the original remote
®
e CONTROL e Vehicle e
profiles
®
e CONTROL e HomeLink®
)
®
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
133