Porsche 911 2020 Owner's Manual page 42

Active Parking Support
> Please see chapter "Surround View" on
A
page 184.
B
> Please see chapter "Active Parking Support"
C
on page 37.
D
Information
E
Observe any country-specific laws relating to the
F
use of parking assistance systems with remote
G
control.
H
System limitations
I
The system limits of active parking support apply:
J
> Please see chapter "System limitations" on
K page 37.
In addition, the following conditions apply:
L
The system is not available:
M
If the Bluetooth connection between cellphone and
®
vehicle is affected by interference from other
N
devices.
O
The system cannot detect:
– Objects in garages above the detection area (e.g.
P
garage door linkage, and other objects that are
Q
not touching the ground).
– Objects that are very low or lying on the ground.
R
– Very narrow or protruding obstacles (e.g. parked
S
bicycles).
– Double garages.
T
U
Functions
With remote parking, the functions of the active
V
parking support can be controlled via the app with
W
remote-control function outside the vehicle.
> Please see chapter "Active Parking Support" on
X
page 37.
Y
Z
1. Name and function changes reserved
40
Parking
Parking is active under the following conditions:
– Parking backward into parking spaces parallel to
the road.
– Reversing into parking spaces perpendicular to
the road, between two parked vehicles.
– Driving forward into parking spaces perpendicu-
lar to the road, between two parked vehicles. A
parking procedure can also be started here if the
front of the vehicle is already positioned in the
parking space.
– Forwards into single garages (minimum width at
the narrowest point 8.5 ft. (2.60 m)) when the
vehicle is positioned as straight as possible in
front of the single garage.
Pulling out
Pulling out works:
– Forwards out of parking spaces parallel to the
road that are at least approx. 3.3 ft. (1 m) longer
than your vehicle.
– Forwards perpendicular to the road to the left or
right.
– Straight reversing perpendicular to the road.
– Reversing out of single garages (minimum width
at the narrowest point 8.5 ft. (2.60 m)).
Preparing the cellphone
In order to use a cellphone for remote parking, it
must be paired with the active parking support.
b b Porsche Connect App
is installed on the
1
cellphone.
1. Open the Device Manager in the PCM. To do
this, select or in the header (depend-
ing on the connection status).
2. Select FernPark .
3. Open the Porsche Connect App
1
cellphone.
4. Select in the app.
5. Follow instructions in the app.
> Please see chapter "Apps" on page 64.
Information
Further information about Porsche Connect (Help
videos, Porsche Connect operating instructions and
Questions & Answers) can be found at www.por-
sche.com/connect..
Resetting pairing
In the event of connection problems between cell-
phone and PCM, the pairing must be reset.
1. Open the Device Manager in the PCM. To do
this, select or in the header (depend-
ing on the connection status).
e Delete paired devices
2. Options
3. Select the connected cellphone for remote
parking.
4. Select Delete.
5. Delete all connections to the vehicle in the set-
tings menu of the cellphone.
6. Carry out the steps for "Preparing the cellphone".
on the