Ses; Zoning; Before Zoning - Western Digital Ultrastar ScaleUp SE4U102 User Manual

User Guide
}
Step 5 : To activate the firmware, send a POST request:
• For an automatic activation, send the POST request to the
the
curl -X POST -k -u admin:admin -H "Content-type: application/
json" https://<IP address>/redfish/v1/UpdateService/Actions/
UpdateService.FWActivate
• For a non-automatic activation, reset the IOMs manually by sending sequential POST
requests to the
curl -X POST -k -u admin:admin -H "Content-type: application/json"
Chassis.Reset
curl -X POST -k -u admin:admin -H "Content-type: application/json"
Chassis.Reset
4.6 SES Page 02
The SCSI
Send Diagnostic
SES element in the enclosure. There are many different element codes, such as Page 02, defined to cover
a wide range of devices. Page 02 refers to the control and status of the enclosure's PSUs, HDDs, ESMs, and
sensors.
Note: Refer to the SES Firmware Management Interface Specification for more information on
SES Page 02.
4.7 Zoning
Caution: Zone configuration should only be performed during a maintenance window, when
the system is offline (not in production).
4.7.1 Before Zoning
This section provides information on actions that should be taken before starting zoning on the Ultrastar
Data102 .
Users should install all of the required downloads before beginning the zoning process.
Required Downloads:
• SMP Tools 0.98 for Linux:
• SG3 Utils:
http:/ /sg.danny.cz/sg/sg3_utils.html
UpdateService.FWActivate
Note: This command will perform a rolling reset of the IOMs.
object using the
Chassis
https://<OOBM IOMA-IP Address>/redfish/v1/Chassis/IOModuleAFRU/Actions/
https://<OOBM IOMB-IP Address>/redfish/v1/Chassis/IOModuleBFRU/Actions/
and
Receive Diagnostic Results
http:/ /sg.danny.cz/sg/smp_utils.html
command:
command:
Chassis.Reset
commands can be addressed to a specific
4. Management
4.6 SES Page 02
object using
UpdateService
220