Western Digital Ultrastar ScaleUp SE4U102 User Manual page 153

User Guide
d. Connect the Ethernet cable to the Ethernet port, and route the cable through each of the
baskets on the arm.
e. Connect the SAS cables to the SAS ports, and route them through the baskets one at a time.
Make sure to follow the labels to ensure they are connected to the proper ports.
f. Connect the power cable to the PSU.
g. Attach the cable retention mechanism.
For PSUs with the clip-style retention mechanism, loop the clip around the power cable and
pinch it until the clip catches and locks in place. Then slide the clip forward until it stops
near the cable connector.
Figure 152: Clip-Style Cable Retention
Figure 153: Cinching Cable Retention Clip
Attention: Make sure the power cable is not connected to a PDU. If it is,
the system will power up when the cable is connected to a PSU. This is not
intended at this stage of installation.
3. Support
3.8 Rails Replacement
137